Posted by Rob Snyder
I am trying to figure out if AutoCAD Civil3D Land Desktop 2008 will adjust an open traverse. I have a 6 mile traverse and have static GPS control points on both ends and a set in the middle. We started off from the two GPS control points in the beginning and tied into the ones at the end.
The GPS points were post processed using Trimble Business Center and the traverse adjusted from ground to grid using the combined scale factor. Any help with if AutoCAD will adjust an open traverse would be appreciated.
To read the rest of this thread, go to www.rpls.com/forums/viewtopic/2/1275965
Open Traverse Adjustment - AutoCAD
January 28, 2011