Point of Beginning

Carlson Question

September 24, 2008

Posted By Perry Williams on 9/23/2008 at 10:30 PM

I was entering a railroad plan into Carlson creating a series of curves, tangents and ROW width jogs.

I took these series of lines and arcs and used NEARJOIN to construct a polyline that represented the boundary.

I then used MOVE & ROTATE commands line up the polyline with the monuments found.

At some point the ARCS in the polylines converted to a series of short line segments. What happened to my arcs?

I guess they were 3D polylines.

To read the rest of this thread go to www.i-boards.com/bnp/pob/messages.asp?MsgID=1278190&ThreadID=121882&IsResponse=False#1278190