More AutoCAD help, description key needed
OK, been a while since I set up a Desc Key. How the heck do you get it to key off the second word. In other words, if they shot 18" RCP and 18" OAK, how do i get it to differentiate from the OAK or RCP rather than putting both on the same layer because of the stinking 18" being first. I cannot get it to "see" the space. so if I put a space in the desc key, it does not use it at all.
To read the rest of this thread go to www.i-boards.com/bnp/pob/messages.asp?MsgID=1394386&ThreadID=132225&IsResponse=False#1394386.